Toolbox Ender 5

thingiverse

I have a tool box that perfectly fits on my Ender 5 Pro printer, taking into account its maximum build volume to prevent the bed from hitting the top of the box. The inside measurements of the toolbox are approximately 100x220x35 mm. It's also compatible with the bed supports I downloaded from Thingiverse and installed on my printer, as shown in the attached pictures. By using caps that slide into place, the box can be opened when the bed is in its lowest position. I printed the caps out of PETG for flexibility, while the box itself was printed with PLA. Supports may be needed for the vertical holes and horizontal sleeves inside the box. I recommend printing supports everywhere to ensure a successful print. You might need to adjust the build plate volume in X-Y to 230mm in Cura or use the Creality slicer when printing the top cap. I secured the box to the Ender frame using two M5x30 mm bolts and T-nuts, which are easily installed on the frame. On the back side of the control unit, there are vent holes that accept M3 bolts, allowing for a more secure mount if desired. To facilitate this, I created slots in the toolbox where these M3 bolts can fit. For optimal print orientation, please refer to the attached images.