Tool Holder v1 for 4mm Bits and screwdrivers for 96 bits!

thingiverse

ATTENTION: New Design Available Here: https://www.thingiverse.com/thing:3725638 - Offers A Lot Of Useful Features, But Lacks IKEA Peg Board Compatibility. I Created This Item Because I Grew Tired Of The Inconvenience Caused By 4mm Bit Holders From China, Which Were Plastic Pieces With Rows Of Holes That Took Up Space In My Drawers. These Holders Were Unusable And Forced Me To Constantly Look For The Right Bits, Making It Difficult To Combine Sets. This Holder Can Store Up To 96 Bits (5 Rows Of 16 And 2 Banks Of 8 On Top) As Well As 3 Screwdrivers With A Diameter Of Up To 16.5mm, Accommodating Most Chinese Pen-Style Screwdrivers. The Holes Also Perfectly Fit Edding 3000 Type Permanent Markers. 96 Places For Bits Are Plenty To Sort My Collection And Have Some Space To Spare For Organizing Them By Kind. It Can Accommodate Long As Well As Short Bits And Has Enough Room In Between For Thicker Nut-Style Hex Driver Bits. The Bit Holes Are About 7mm Deep, The Screwdriver Holes Are >20mm Deep, Which Should Lead To A Solid Hold And Tools Should Not Fall Out. On The Back Are 2 Slots For Hanging This On Screws With 120mm Separation, Making It Possible To Attach It To A 40mm Pegboard. Because This Part Is Kind Of Big And Therefore Expensive, I Included A Smaller Variant (Same Side Profile, Same Hole Sizes) That You Can Use To Test-Print And Check Before Committing To Printing The Large One. This Is Kind Of A "Works For Me" Thing. Much Could Be Improved, But It Works Well For Me, So I Did Not Optimize Further. If You Look At The Picture With The Several Mini Variants, You Can See I Started Out With A Concave Arrangement But Noticed That The Bits Are Quite Hard To Pick Up From That And The Longer Bits Are Close Together At The Tip. I Changed To A Convex Arrangement, Which Is Much More Usable Even If More Expensive To Print. You Should Print This Because It Has 96 Bits! Your Computer Probably Only Has 64bits So This Is 32bits Better!