Tool holder for Wanhao Duplicator i3

thingiverse

A tool holder for Allen keys and scraper for your Wanhao Duplicator i3, expertly redesigned by Chai_Yu_Zheng to eliminate super-gluing requirements.\nChoose the clip-on-left/right/middle files depending on where you want to clip the tool holder. To mount on the left hand side as shown in the picture, select clip-on-left. When looking at the face of the clip, left or right is correct. The untested clip-in-middle version should fit in the same hole but facing forwards.\nIncluded gcode files incorporate a raft and print at 200 Celsius extruder temperature and 70 Celsius bed temperature. This may be a bit high; I can modify these settings if desired.\nPrint Settings\nPrinter: \n Wanhao Duplicator i3\n \n Rafts: Yes\n \n Supports: Yes\n \n Resolution: 0.2mm\n \n Infill: 20%\n \n Notes: A support should be placed under the clip as in the picture. You may find that the end of the scraper hook lifts off the bed without a raft. I was lucky once or twice but ended up using a raft. PLA was used, and the glass bed remained at 70 Celsius throughout.