Tool head screw holder Snapmaker 2.0

thingiverse

This small add on captures the tool head screws when changing models for the snapmaker 2.0. i have it on a snapmaker A250T top and bottom, unkown if it fits other models. because of the tight gap between the rail and the screw head it is imortant to have a well calibrated printer and to use sand paper to thin the plastic down. i used a small gclamp to press the cover in place and ran the .1mm plastic guage to check for clearance. to remoe the cover i drill the spiggots out with a 3.5mm drill and print a new one. i was going to insert a tiny screw in the center of the pin to swage lock it inplace but found no need. hopefully i explaned this ok but ask if confused.