Tool changer Ender 5

thingiverse

Attached is my firmware for the SKR1.3. Use at your own risk, do not leave unattended, as I will not be responsible for any damage or negative results of using the firmware. The system adapts the Satana fan duct and works effectively. To switch tools, use stare and end Gcode commands. You'll need some 5mm silver steel or pins and 12x4mm countersunk magnets for M4 to get started. Adjust the nozzles so that they're as close to being even in height as possible. Moving the heat block might be necessary to achieve this; remember to tighten everything back up afterwards. Cure glitches will occur when printing the brim with T0; it may randomly go to 0,0 and crash. To stop this, set the brim to use T1 instead. Position offset can be configured in Cure by adding start and end codes to the print config. Start the machine with both extruders on the fixtures. Start code T0: G90 G1 X215 F10000; G1 Y15 F10000; M280 P0 S70; G1 X115 F10000; G1 Y200 F10000;picked up G90 End code T0: G90 G1 X115 F10000; G1 Y15 F10000; G1 X215 F10000; G1 Y15 F10000; G1 X225 Y30 F800; G90 Start code T1: G90 G1 X15 F10000; G1 Y15 F10000; G1 X115 F10000; G1 Y200 F10000;picked up G90 End code T1: G90 G1 X115 F10000; G1 Y15 F10000; G1 X15 F10000; G1 Y15 F10000; G1 X5 Y30 F800; G1 Y200 F10000 G90