tool- and penholder - deskorganizer - modular - boxes - easy to print version

thingiverse

A comprehensive Slic3r settings configuration! Here's a breakdown of the various sections and their corresponding settings: **Printer** * `Inverted Y axis`: Enabled (this means that the Y-axis is inverted, which can affect print quality) * `Default extrusion width`: 0.45mm (the default width for most prints) **Perimeters** * `Solid infill every`: "0" layers (no solid infill) * `Fill angle`: 45° * `Solid infill threshold area`: 0 mm² (no minimum area required for solid infill) * `Bridging angle`: 0° * `Only retract when crossing perimeters`: Disabled * `Infill before perimeters`: Disabled (perimeters are printed first, allowing them to cool down and creating a smoother surface) **Skirt and Brim** * `Loops`: 1 (only one loop of the skirt) * `Distance from object`: 2mm * `Skirt height`: 2 layer * `Minimum extrusion length`: 4mm * `Brim width`: 0mm (no brim) **Support Material** * `Generate support material`: Enabled (support material is generated for the rails) * `Overhang threshold`: 45° * `Enforce support for the first`: "0" layers (no support for the first layer) * `Raft layer`: "0" layer (no raft) * `Contact Z distance`: "0.2" (detachable support material) * `Pattern`: Rectilinear * `Support sheath around the support`: Disabled * `Pattern spacing`: 2 mm * `Pattern angle`: 0° * `Interface layers`: "2" layers * `Interface pattern spacing`: 0.2 mm * `Interface loops`: Disabled * `Support on build plate only`: Enabled (support material is generated for the rails only) * `XY separation between an object and its support`: 0.4 mm * `Don't support bridges`: Enabled **Speed** * `Perimeters speed`: 45mm/s * `Small perimeters speed`: 25mm/s * `External perimeters speed`: 35mm/s * `Infill speed`: 170mm/s * `Solid infill speed`: 170mm/s * `Top solid infill speed`: 50mm/s * `Support material speed`: 50mm/s * `Support material interface speed`: 100% (full speed for support material) * `Bridges speed`: 30mm/s * `Gap fill speed`: 40mm/s * `Travel speed`: 180mm/s **Modifiers** * `First layer speed`: 30mm/s **Acceleration Control** * `Perimeters acceleration`: 800mm/s² * `Infill acceleration`: 1500mm/s² * `Bridge acceleration`: 1000mm/s² * `First layer acceleration`: 1000mm/s² * `Default acceleration`: 1000mm/s² **AutoSpeed** * `Max print speed`: 170mm/s * `Max volumetric speed`: 0 mm³/s (no maximum volumetric speed) * `Max volumetric slope positive`: 0 mm³s/s² (no maximum positive slope) * `Max volumetric slope negative`: 0 mm³s/s² (no maximum negative slope) **Advanced** * `Default extrusion width`: 0.45mm * `First layer extrusion width`: 0.6mm (wide first layer for better adhesion) * `Perimeters extrusion width`: 0.45mm * `External perimeters extrusion width`: 0.45mm * `Infill extrusion width`: 0.4mm (smaller infill width for stability) * `Solid infill extrusion width`: 0.7mm (larger solid infill width for faster fills) * `Top solid infill extrusion width`: 0.45mm (standard top solid infill width) * `Support material extrusion width`: 0.35mm **Other** * `Clip multi-part objects`: Enabled * `Elephant foot compensation`: 0mm * `XY size compensation`: 0mm * `Resolution`: 0mm