tool- and penholder - deskorganizer - modular - boxes

thingiverse

This appears to be a configuration file for a 3D printer, specifically Cura. I'll break down the settings into sections for easier understanding: **Infill** * Infill every "0" layers: This means that infill will not be printed at all. * Fill angle: 45° * Solid infill threshold area: 0 mm² (this setting is usually used to control when solid infill should be used, but with a value of 0, it's disabled) * Bridging angle: 0° * Only retract when crossing perimeters: Disabled * Infill before perimeters: Disabled **Skirt and Brim** * Skirt loops: 1 * Distance from object: 2mm * Skirt height: 2 layers * Minimum extrusion length: 4mm * Brim width: 0mm (this means that no brim will be printed) **Support Material** * Generate support material: Enabled (only for the rails) * Overhang threshold: 45° * Enforce support for the first "0" layers * Raft layer: "0" layer * Contact Z distance: "0.2" (detachable) * Patter: Rectilinear * Support sheath around the support: Disabled * Pattern spacing: 2 mm * Pattern angle: 0° * Interface layers: "2" layers * Interface pattern spacing: 0.2 mm * Interface loops: Disabled * Support on build plate only: Enabled (support will only be generated for the rails) * XY separation between an object and its support: 0.4 mm * Don't support bridges: Enabled * Synchronize with object layers: Disabled **Speed** * Perimeters: 45mm/s * Small perimeters: 25mm/s * External perimeters: 35mm/s * Infill: 170mm/s * Solid infill: 170mm/s * Top solid infill: 50mm/s * Support material: 50mm/s * Support material interface: 100% * Bridges: 30mm/s * Gap fill: 40mm/s * Travel speed: 180mm/s **Modifiers** * First layer speed: 30mm/s **Acceleration Control** * Perimeters: 800mm/s² * Infill: 1500mm/s² * Bridge: 1000mm/s² * First layer: 1000mm/s² * Default: 1000mm/s² **Autospeed** * Max print speed: 170mm/s * Max volumetric speed: 0 mm³/s * Max volumetric slope positive: 0 mm³s/s² * Max volumetric slope negative: 0 mm³s/s² **Advanced** * Default extrusion width: 0.45mm * First layer: 0.6mm (wide extrusion for smooth first layer) * Perimeters: 0.45 mm * External perimeters: 0.45 mm * Infill: 0.4 mm (stable infill lines) * Solid infill: 0.7 mm (faster filling of solid areas) * Top solid infill: 0.45 mm (smooth surface) * Support material: 0.35 mm **Overlap** * Infill/perimeter overlap: 30% (good bonding between infill and perimeter) * Bridge flow ratio: 0.95 **Other** * Clip multi-part objects: Enabled * Elephant foot compensation: 0mm * XY size compensation: 0mm * Resolution: 0mm