Tonuino Case

thingiverse

I crafted my own case for the Tonuino Project: https://voss.earth/tonuino This custom enclosure was created using PLA+ in three distinct colors: silver, white, and transparent. Here are the key components I utilized: • Switch: https://www.ebay.com/itm/Mini-Kippschalter-Wippschalter-Switch-2-Pin-250V-3A-125V-6A-Ein-Aus/184189464527?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649 • Arduino Nano • DFPlayer mini • 3W 4Ohms Speaker (52mm) • RFID module MFRC522 • 13,56 MHZ RFID Coins (20mm) • P4056 Lithium Li-ion charging and protection module • 18650 Li-ion cell • Mini USB breakout board (battery charging and SD-card data transfer) • 5V StepUp • Two diodes • Three 6x6x6mm tactile buttons • Two 1k resistors (for RX/TX on the mp3 player) • Self-tapping screws (M2x5mm, M2x8mm & M3x5mm) • 1206 led green (I replaced the red LED on the RFID module with a green one and placed it on the backside using the led pads from the original red LED) If you prefer to power the box via mini-usb cable instead of running it on battery power, feel free to remove the following components: the 18650 cell, the step-up, the diodes, and the charging module.