Token Tray for Alchemists boardgame

prusaprinters

Token Tray for the tokens in the game Alchemists. Fits about 19 in the 4 long channels and 9 in the 4 smaller channels in the back.It is made to close with magnets, I used 8mm diameter x 0.8 mm thickness, but the magnet spots are oversized to fit up to 10 mm diameter and 1 mm thickness.To hold tighter I had to put 2x magnets in the back. In retrospect I should have probably just put 2 magnet spots on the back instead of the 1, but with the angles it was just easier to design with the 1.I took into account the angle of the token cylinders so the lid should be able to freely come on and off vertically, but in practice the tolerances on the lid could have been abit larger so it can take a little wiggling to get it to close. Not a big deal, but a little annoying.There are two top designs, the one in the pictures is the 'fancy' one. It is a little harder to print because of the overhangs it will cause. I printed it on the largest part of the top and did support for the other top angle. The steep angle there made it a little annoying to scrape away the supports. The simple lid will take a little more material but should print very easily upside down.The tokens in the picture are 3d printed replacements for the slightly oversized cardboard chits that came with the game. You can find them here: https://www.printables.com/model/209384-tokens-for-alchemists-boardgame