Token/Coin Dispenser and Storage Container

cults3d

Ever go to the car wash or other place that requires use of tokens and get a few bucks worth of tokens, ending up with some extra to keep for your next visit. Enter the Token/Coin Storage and Dispenser, designed to hold tokens with easy retrieval for your next visit. These were made to store car wash tokens that are roughly 1.6mm thick and 25mm in diameter but work just fine for standard U.S. Quarters by sanding the slot slightly; please comment on what else they work for. The Short Dispenser body holds over 20 tokens, while the Long version holds about 40. Print three Spacers for the Long version, then glue two of them back to back using the center hole to align; this creates the center Spacer. There's just one catch: you'll need a metal spring. I looked everywhere for an affordable and available spring and settled on this one: https://www.acehardware.com/departments/hardware/specialty-hardware/springs/5214614 - free shipping to a local store. A better spring was once available on Amazon but is no longer; feel free to comment if you find another one that becomes available. You can easily modify the spring slots in the cap and Spacer to fit another spring, but be careful it needs to stay near the spring rate/load capacity.