Toilet Roll Radiator Clamp

thingiverse

We didn't have enough space or energy to mount a toilet paper roll holder to the wall, so I designed one that fits onto our radiator perfectly. This design can be printed without support, as long as it's turned correctly with the flat side facing down on the bed. The rod should be printed upright at all times. Adapting this design to your specific radiator should be relatively easy. In most cases, simply adjusting the length of the rod will do the trick, but you may also need to modify the width of the clamps themselves to fit properly. **CAUTION**: Our radiator tends to run cold even when we're heating it up, so that's not a problem for us. If your radiator is hot, however, this design might not work as well, especially with PLA filament. Be sure to check the melting temperature of your filament before printing.