Toilet Paper Protector (OLD/REPLACED)

thingiverse

UPDATE: DEC. 2019 - Earlier this month my TP Protector Mk2 here had a critical failure on one of its supporting loops. It wasn't working quite as flawlessly as I imagined, and the cat could still get to the paper from the top if she was feeling particularly ignored and needed to let me know by eating some more paper. I think she was also pulling down on the part that caused the critical failure in the loop. I've gone back to the drawing board and designed a new version which should be much more sturdy and provide better protection. Updated version available here: https://www.thingiverse.com/thing:4064251 I adopted Trixie back in May, and she's proven to be incredibly happy, loving, and friendly with me... but not so much towards my toilet paper. A couple of weeks ago, she developed a habit of chewing on it. Not a huge problem, but kind of weird considering its purpose, so I wanted to deter the behavior. I turned to my old friend 3D printing to help. I found a few 3D models that would work, but only one that looked like something I'd want. I tried it, but it actually didn't cover enough of the roll in my opinion. Between it not covering enough of the circumference of the roll and its length being a bit short, it just rolled around on the shaft a lot, leaving most of the roll exposed. I did an initial design in Fusion 360 that was basically a cylinder with a chunk missing, but it proved both too long and difficult to print. It fit on the roll but brushed up against the arms more than I'd like, and the cylinder design meant it had to be printed on its side, but the missing chunk meant there was a good bit of supports and bridging that wasn't terribly successful on my FLSun QQ-S. I went back to the drawing board (or sketch editor, I guess?) and decided a polygonal design would print much easier while I shortened it up by 1cm. I could have cut the length more but decided against it since it blocks more of the roll. I'm pretty happy with how this turned out. It's more than generic enough that it should work with almost any toilet paper roll holder of standard length, and should fit any standard-sized rolls, likely will fit the slightly larger than standard rolls (in terms of how much paper is on the roll). I've had it on for a few days now and haven't found any bite marks on the roll so I'm guessing it's working. Designed with 4mm total width walls to give it enough mass to be very unlikely to break or snap, printed with 2 perimeters (0.8mm walls on a .4mm nozzle) and 10% infill. Pictured TP Protector was printed on a Prusa i3 MK3S in Prusament Galaxy Black PLA. No raft, no brim; I did use support enforcers in PrusaSlicer to support the rings for a smoother finisher but it's not absolutely necessary. Model is oriented so it should just work.