Toilet Paper Ply Divider Using Prusa MMU2S Spool Holders

prusaprinters

<p>If you already have the Prusa Enclosure V2 with MMU2S support, then all you need is 3 small parts, a rubber band, and a board to make this handy toilet paper divider. This will come in handy, especially during the great toilet paper shortage of 2020, to help divide your ply's and stretch your TP to last just a little bit longer. Best of all, all parts are press fit so just pull them apart when you're all done and put your multi material setup back the way it was. Best of all, it only requires 4 of the rods from the spool holders so you're still left with one to keep on printing one color at a time. Kit comes with two different sizes for the rubber band holder to adjust for the right amount of grip or the right size for your rubber band to keep the two rolls in sync while you roll. The spool holders don't fit on a TP holder, but I'm sure you'r clever enough to rig up something for that too :-) I just set mine on the tank.</p> <h3>Print instructions</h3><p>25% Grid Infill<br/> 2 Perimeters<br/> 3 Solid Layers Top and Bottom<br/> 0.25mm Layer Height</p>