Toilet Paper Holder

prusaprinters

A simple toilet paper holder designed to go well with the PVC towel rack I made.Materials: Use any materials you like, but avoid those that are particularly brittle.  This design is better for FDM printing than resin due to its size and typical nature of the materials.You will also need:(2-3) screws 5mm (I purchased mine at Ikea)(1-3) dry wall anchors as needed(optional) mild glue to hold screw covers in place.Directions:Align the flat surface that will be against the wall as the bottomA raft is recommended.  I printed with a 5mm clearance to reduce material waste.Supports are required for the main rod.This should be printed oriented so that the open end of the rod points away from the user.  Mirroring may be required.To mount to the wallplace your print against the wall where you want it, then lower it by about half an inch (~13mm).note where the rod moves outward from the wall and mark this point for your anchor screw.  Put a screw in the wall leaving 3mm clearance from the head to the wall.put the keyhole mount onto the screw, align the print so the outer rod is level to find the location for your other two screws.alternatively you may use the primary screw holes and strong adhesive (or double sided tape)insert the screw cover plugs.  You may need a little glue to help hold them in place.  Choose something with a bit of bulk and a relatively weak bond.add a roll of paper