Toilet Flush Arm Extender

prusaprinters

<p>For a while, I was struggling with the flapper valve in my toilet getting stuck open which wastes water if left unaddressed. First, it was getting caught on the chain so I adjusted that which reduced the frequency of the flapper getting stuck. However, the flush arm is just barely long enough that the flapper can get hung up on the tip. I tried adjusting the arm and flapper position to no avail. I figured this could be solved by simply extending the arm which worked like a charm.&nbsp;</p><p>The extender fits right over the arm and has a flexible clip that hooks into the hole in the arm. This prevent the extender from sliding off over time. To remove it, press the clip through the hole with something long and slender (like a toothpick or nail) to disengage the clip.&nbsp;</p><p>Print instructions:</p><ul><li>No supports</li><li>Print orientation: Print on side rectangular cut-out facing up</li><li>Layer height: 0.20mm</li><li>Shells: 4</li><li>Infill: 25%</li></ul>