Toggle Switch Housing + Mount

prusaprinters

<p>I created this toggle switch housing to control the LED lights in my 3D printer's enclosure. It is intended to enclose a panel-mounted switch with a panel cutout of 28.5 mm x 13.5 mm and a depth of no more than 37.5 mm. It can be mounted using 2x 8mm screws.</p><p>There is a 5mm diameter hole on either side of the rear of the enclosure to accommodate the wires used to connect the switch to the circuit.</p><p>This model was created from scratch, but was inspired by <a href="https://www.printables.com/social/1233-alberto-nidasio">Alberto Nidasio</a>'s light switch mount design.</p><p>No supports needed. Any material should work, but I used PETG. Just feed the wires into the holes in the enclosure, solder them to the switch and press-fit the switch into the front of the housing.</p>