TOBECA 2 FAN

thingiverse

Customized version of Thingiverse.com Created with Customizer! Instructions Using the options below: File Setup: $fs = 0.5mm, Layer Height. Clip Clearance is 0.3mm. Duct Height = 65mm. Angle = 45 Degrees. Screw Head Diameter = 4.3mm. Screw Distance = 15mm. Nut Correction = -0.5mm. Thickness of Material = 2mm. Clamp Extension = 6mm. Duct Scaling = 0.209 (for diameter only). Fan Screw Head Diameter = 6mm. Nut Clearance = 0.2mm. Central Base Multiplier is set to 1x. Countersink setting: yes. Screw Head Height = 0.3mm. Maximum Building Height = 24mm. Open the duct slightly, allowing an Opening of 1.2mm. Use Clamping Screw Diameter at 2.8mm. Fan Screw Diameter = 3mm. The outer Duct Wall is 1mm thick. Nut Width = 4.7mm. Sphere Diameter = 16mm (inside mount). Mount Extension: 18mm long for external fan housing. Screw Base Multiplier is set to 1.8x the size. Fan Size: use a diameter of 40mm (for motor area). Nut Height is fixed at 1.6mm. Clip thickness equals 1mm. Height of clip is set at 8mm above material. Use screw with a shaft diameter of 2.5mm.