Tobacco carrying case

thingiverse

Remix of Galansky's model fixes some tolerances. Carry all your tobacco, filters, and papers in one neat box. Say goodbye to messy plastic bags or expensive holders that need to be replaced. Rolling papers fit tightly when full and stay in place even with a few left. **Printing Tips:** Print using two walls and tree supports for the back. Use 0% infill as the model doesn't need extra support. I tried breaking it, so trust me on this one. Brim is highly suggested but not necessary. **Post Processing Tips:** After printing, you must clean the grooves in the door sliders. I use a box knife going from inside to outside, pulling loose filament and cutting top and bottom of the groove until the knife glides with ease. Corners will be difficult, but with a scalpel, you should have no problems. Clean and square off the doors as plastic can expand, so a little sanding or cutting might be necessary depending on your printer.