Toad 135 - Micro FPV Quad - (8.5mm Motors)

thingiverse

UPDATE Added fully enclosed hood :) This is a re-work of my Toad 110 frame, extended arms now accommodate 65mm props. Also added camera mount and gap in plate to allow antenna through. Can be used with various brushed fc's available now, use eachine naze32 board and separate flysky sbus rx. Standard quadcopter FC with cleanflight/betaflight also works with ESC output in brushed motor mode and some custom 6.2 Amp Brushed ESC's. Getting decent flight times out of them, extra weight on props gives decent yaw, even flips! Plate is optional, attach with M3 Spacers in your preferred configuration. Parts list: Toad 135 3D Printed PLA Frame Eachine Naze 32 Brushed FC Eachine TX02 with Dragon FPV 5.8G Mini Clover Betaflight 8.5 Motors 65mm Props 1S 200-400Mah Lipo M3 Hex Spacer 10-15mm *8 Print Settings: Printer: Prusa I3 Rafts: No Supports: No Resolution: 0.2 Infill: 50-100% Notes: Usually print in PLA, things usually hold up to heavy crashes, most of the time it's all fine. Infill amount depends on your weight/strength requirements. Custom Section