TMoS' Card Containment System

thingiverse

Special thanks go to Alexander Pruss for developing and supporting the included fontmetrics package: https://www.thingiverse.com/thing:3004457 fontmetrics is covered by https://creativecommons.org/licenses/by/3.0/ TMoS' Card Containment System is covered under https://creativecommons.org/licenses/by-nc-sa/3.0/us/ please use and share this, just give credit where it's due! let me know if you make changes or have ideas for improvements! TMoS' Card Containment System Creates a box with slots to separate cards. and/or Creates a box with a compartment large enough to hold one configurable sized deck of cards. Also allows for extra room above the cards/dividers for storing extra stuff The appropriate lid and dividers can also be created. Text can be placed on up to three sides, the Lid, the End face, and one of the side faces by assigning the text to LidText, EFText, and SFText Set the text values to "" (blank) to not have any text on that face The size of the text can be scaled by setting a scaling factor >0 and <=1 LTScale, EFScale, and SFScale set this value Text will scale to fit the dimensions of the appropriate box/lid face and be multiplied by the supplied scale factor text for each face can be aligned along the long or short side of the box by setting LTAlignLong, EFAlignLong, and SFAlignLong (boolean values) Use the display flags at the end of the variable definitions to display 1 or more components for rendering. NOTE: if you have more than one component active the render will be the union of all the active components! When printing the lid I would recommend flipping it 180 around the X or Y axis When printing the dividers, flip them 90 around the Y axis Card Deck Dimensions The card dimensions are based on a deck of cards sitting on a flat surface as one would draw from it. if CardZ is set to '0', it is assumed that dividers will be used to separate cards in a box of MaxBoxLength size, slots for the dividers will be cut into the sides and bottom. Future Opportunities: Support multi-line text Revision History: 5/10/19- corrected bug in near and far fillet corners that caused non-manifold issues (extra volumes) Added ability to define the number of sections the box needs to support and a minimum internal size (MinDeckHeight) corrected bug in Dividers that messed with the finger gap if ExtraHeight was > 0 Defined some 'standard' card dimensions as vectors to make them easier to work with Changed the default MinWallThickness and DividerBite to give the dividers less chance to pop out of the slots Changed the defaults for FingerGrab and FingerGrabLen (my fingers are fat) I've supplied the box and lid STLs for a standard size deck of cards.