TLR 22 SCT 3.0 Lowrider (ish)

thingiverse

This is a few parts to make a big handling improvement on the TLR 22 SCT 3.0 for very little cost. It's not as good a the full lowrider kit but since you can actually get these parts its worth a try. I run on indoor high bite clay and was amazed by the difference just these parts made. It also shaved about 30 grams of weight off the car, mostly from shorter wires. Battery Forward Mount: These parts only require you to use longer screws and go through the mud guard for the front two screws. The rear mount will fit over the stock post and work with the body pins but might need a little foam to keep pressure on the battery. I use some after market threaded posts and thumb screws. There is also a channel to run wires along the side of the mount. You can print the LCG adapter insert part to run LCG batteries if you want. There is 36mm between the waterfall and the back of the battery tray Shock Limiters: These are used to reduce droop to get a similar travel to the low rider kit from RCLYFE without needing to get different shocks. 10mm in the rear shocks and 6mm in the front shocks seemed about right for me with the ride height around 20mm. I also incuded an extra long part you can trim down in your slicer if you want to play around to find was works best for you.