Titan Dynamics - Falcon. Wing Connector

thingiverse

This design is to include quick connect connectors in the wings and fuselage of the Titan Dynamics Falcon. You will need to put the ESC's in the wing cavity behind the connectors (thats what the shelf is for). Print 2x each Wing + Fuselage Inserts, plus 4x Spacers. I split each connector part into two pieces so it could be printed without supports, thats why you need the "spacers". Also, this makes it so you can glue the final piece flush with the end of the wing/outside of the fuselage and have perfect engagement length for the connectors. Print in PETG, 3 wall to make it solid. Once all wired up, glue the inserts into the wing/fuselage cavity. You will still be able to unscrew the connector and pull the wiring through for maintenance etc so leave a bit of extra length available behind the connectors. If you are putting VTX and RX in the wings, you will likely also have to share some pins for 5v supply and ground cables as theres only 9 smaller pins, but I have done this myself and it works flawlessly. Designed to work with JX9 Connectors from Ali Express. https://www.aliexpress.com/item/1005001859546029.html?spm=a2g0o.order_list.order_list_main.47.7afb1802OfSGSB Tip: The inserts are a snug fit but do not force them in to the wing/fuselage... if needed sand the outer faces slightly until it goes in without any force to avoid breaking the LW-PLA parts. The glue will hold it plenty strong enough once you glue them in. Also, ideally you will use quite small ESC's to fit on the shelf/in the cavity easily... these HakRC 35A BLheli32 ESC's are great (also no calibration required): https://www.banggood.com/HAKRC-BLHeli_32-Bit-35A-2-5S-ESC-Built-in-LED-Support-Dshot1200-Multishot-for-FPV-RC-Drone-p-1277587.html?cur_warehouse=CN