Titan Aero FanDuct - theUGLY

thingiverse

I finally found a FanDuct that works with Titan Aero. It uses the standard 50mm blower and the [fan holder by GaryK47](https://www.thingiverse.com/thing:2367407). I tried several ducts, but they all scattered air around and didn't focus it properly. I even modified some of them, but ultimately gave up and made one from scratch - it's not pretty, but it works surprisingly well. To assemble the FanDuct: - Print it - Push the fan duct into your blower - Attach the blower to the fan holder - You're done! It prints easily without support in PETG and ABS. I'm skeptical about printing it with PLA, so I haven't tried it myself, but if you do, please let me know how well it performs. The V2 version has better cable management and is slightly lighter. You can find the source on [onshape](https://cad.onshape.com/documents/fd51fde993c5b5bbaae5f962/w/e034ba3a3c42e0e3c0d6b734/e/d5739f7556bbd00756e44142). P.S. The white grid on the new fan (I replaced it with a super quiet SunOne Maglev that has high air throughput) is printed from [thing:2335067](https://www.thingiverse.com/thing:2335067) in TPU, and I also printed a similar piece between the fan and heat sink, both in TPU. They should help create a more laminar airflow, but in reality, they're just there because I couldn't find the right screws - so I added this 7mm "distancer" to make it work with longer screws. The white pieces on the part are also just fat TPU washers, as the screws were too long.