Tippmann TMC Air-Through Adjustable Stock Tank Spacer

thingiverse

This spacer goes on top of the bonnet on the Tippmann HPA tank to keep tank from being misaligned. On both my 13ci tanks the gauge was in the down position preventing the support arm from raising up to the bottle. This has been tested on 13ci and 26ci tanks to ensure the air seal remained in tact between the bottle and the marker, even though there is currently no 26ci stock that would work for these purposes, I may make one at some point. Even with 100% infill this does not take a lot of filament or time printing. You may have to increase/decrease the z-height in your slicer to adjust for your needed offset. The current height is just under the threads so I would not recommend raising height more than this. This was created in Sketchup. I may add additional clips with varying thickness to accommodate varying tank threads. If this holds up with use, and given enough interest, I may release the source file.