tip cover #5

thingiverse

Customized version of http://www.thingiverse.com/thing:904304 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=904304 Instructions Using the following options: tip_width is set to 15.25, tip_mid_length is fixed at 6, socket_depth is defined as 26, middle_sides equals 1, tunnel_radius is adjusted to 1.2, middle_height stands at 10, hinge_plug_bulge measures 1.2, socket_thickness comes in at 2.1, hinge_width stands firm at 14.5, socket_width_top reaches 16.75, scallop_left starts at zero, scallop_offset is calculated as 3.5, build_item has been determined to be six, explode mode is inactive, middle_width checks in at 7, tip_length is firmly set at 15.5, socket_hinge_notch measures a fraction under an inch (.75), hinge_nut_width comes out to 4.8, scallop_right has been adjusted to 8, base_width checks in at seventeen, hinge_nut_thickness solidly remains 2, tip_tensioner_screw_radius stands at .85, tip_cover_width stands tall at thirteen point five, base_tensioner_screw_radius is a precise .85, tip_fingernail_ratio comes out to half a unit of measurement (.55), socket_width_bottom spans a whopping twenty-four units, hinge_pin_radius has been carefully adjusted to 1.075, tip_ridge_width firmly checks in at eleven units, base_height is reported to be minus one unit, middle_length measures precisely twenty, knuckles number a pair of two, print_mode sets off the meter reading out 1, rotatetest stands tall at zero, and tip_accessory_radius has been deliberately adjusted to zero.