TinyTrainer GNB 450mAh 4S HV battery holder

thingiverse

I was asked to modify the original TinyTrainer battery strap to fit the GNB 450mAh 4S HV lipo packs, in doing so I came up with the idea of an adding a band to stop the pack from fully ejecting in a hard crash. The idea is you put the battery in as normal, then feed the power cable through the band, so if the battery tries to slide out, the band holds on to the end of the battery & stops it ejecting. Further to modifying it to fit the GNB pack, I also fixed the mount hole alignment, look at the 5th picture to see what I mean. Print in TPU, 0.2mm layer height, no support needed. I've included versions with & without the band. Direct downloads from my website: http://www.haku.co.uk/3d/TinyTrainer_GNB_450mAh_4S_HV_battery_holder.stl http://www.haku.co.uk/3d/TinyTrainer_GNB_450mAh_4S_HV_battery_holder_band.stl You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.