Tinyhawk Freestyle -90° to 90° Full Tilt camera mount

thingiverse

This print lets you mount any 14mm x 14mm nano-sized FPV camera on your Tinyhawk Freestyle at any angle without making permanent modifications! **You'll need to rotate your bottom frame 180° to get clearance!** Required Items: - A 2mm drill bit - A drill bit between 1.7 and 1.9mm - Near complete disassembly of your TH Freestyle to rotate the bottom frame - Replacement zip-ties or tape Directions: 1- Print both pieces and finish by using a 2mm drill bit to clean the screw hole for the camera and the two tabs, then use any drill bit around 1.7 to 1.9mm to drill through the main post. It just needs to be slightly smaller than 2mm so the screws can thread into it. 2- You'll need to completely disassemble the Tinyhawk to rotate the bottom frame 180°. The motors are soldered to the board, so you can either unbolt all four motors and the flight controller or desolder the motors from the board and turn the FC around then resolder. If a motor spins in the wrong direction, simply change its direction with the BL_Heli configurator. 3- Assuming you've sorted out your camera's wiring, attach the camera to the mount and attach it to the frame on what used to be the rear. It simply replaces the nylon posts. You can choose to mount the top plate in either direction. I mounted mine backwards for aesthetics and offset the added length. By the way, the Caddx Kangaroo is an awesome replacement for your stock camera!