Tiny Whoop frame - 1S - 31g AUW

prusaprinters

<p>This whoop is based on Rygar1432's idea, but i designed the model from scratch.</p> <p>FC is secured by the (included) rubber spacers on a separate nylon screws. This reduced a lot of noise coming from the motors into the FC and increased flight stability and time considerably.</p> <p>Model is assembled with nylon standoffs, screws and nuts - <a href="https://www.banggood.com/180-PCS-M2-Nylon-Plastic-Screw-Screw-nutsInsulated-Column-Pillar-Set-For-FPV-RC-Drone-p-1314659.html">https://www.banggood.com/180-PCS-M2-Nylon-Plastic-Screw-Screw-nutsInsulated-Column-Pillar-Set-For-FPV-RC-Drone-p-1314659.html</a></p> <p>In place of battery holder i used jewelry string, it is flexible yet very hard to break - <a href="https://www.aliexpress.com/item/1005002233593961.html">https://www.aliexpress.com/item/1005002233593961.html</a></p> <h3>PARTS:</h3> <p>*<strong>BetaFPV 0802 22000kv motors</strong></p> <p>(They make SE version now which is lighter, and 19500KV option is probably a better tradeoff in flight time/performance) *<strong>BetaFPV F4 AIO Flight controller</strong></p> <p>(Unfortunately they don't sell the FC i have anymore, but the new version should fit just fine, and has VTX already included) *<strong>BetaFPV M01 AIO Camera 5.8G VTX</strong></p> <p>(can be swapped with C01 FPV Micro Camera in combination with the new F4 AIO FC) *<strong>BetaFPV BT2.0 300mAh 1S 30C Battery</strong> *<strong>RKH 40mm 3 Blade Props Clear 1mm shaft</strong></p> <h3>HARDWARE:</h3> <ul> <li>nut - M2 : 4pcs</li> <li>screw - M2*6 : 8pcs</li> <li>Column - M2*6+6 : 4pcs</li> </ul> <h3>PRINT:</h3> <p>I printed the parts with 0.4 nozzle and 100% infill in ABS.</p> <p>Layer height - 0.2mm</p> <p>Line width - 0.4mm</p> <p>Perimeters - 2</p> <p>There are integrated supports under the frame screw holes, you can snap them out with small priers. No other supports needed.</p> <p>Thanks</p> Category: DIY