Tiny Whoop E010 case with tray

thingiverse

Remix of the excellent case by ByteSlinger. I added a middle tray for more batteries, resized the lid to suit my lower whip antenna TW. The tray will be a very tight fit, and most likely need a little sanding on the outer edges before it fits in position. You can sand it to get as tight or loose a fit as needed. I used some 400grit paper and spent ten minutes sanding, fitting etc. I had the 5 pack charger that comes with the 45c E010 batteries from Banggood (very good batteries!). I cut down the wires, resoldered them for less mess, then taped to the inside of the lid as a charging tray. It works well. I printed in PLA (Excelvan green). The print settings were 0.2 layers, which took about 7 hours for the base (!), 6 hours for the lid and about 2 or so for the tray. Quite a long print but the original design of this case is really nice and chunky., it feels good when done. I have a picture of the black case, - the black lid is one I redesigned to have a lower height - it can't fit the charger in the lid space. But prints quicker!