Tiny Top Hat for Dolls and Stuffed Animals -- Center Prints w/o Supports

thingiverse

Here's a tiny tophat I designed for a creature friend. I wrapped mine with black fabric and a tiny ribbon to give it a more authentic look. You can scale this up or down to fit your little friend perfectly. The hat opening measures 39mm x 52mm. The pipe section features a cone at the top, making it easy to print without supports. However, the hat brim does require some support. To get it just right, set your "Support Overhang Angle" to 58 degrees. If you don't, you'll end up with an unwanted support tower in the middle that will be very difficult to clean out.