Tiny Keychain Micro SD Card Holder (for 2 cards)

prusaprinters

<p>Hello,</p><p>this is a holder for 2 micro SD cards that can be attached to a keychain.</p><p>The holder snaps into place easily and is then securely closed. The tab on the side has a snall notch to make it easier to open the holder again.</p><p>I tried to make it as small as possible to reduce the likelihood of it getting tangled on a keyring or in your pockets.<br/>The hole for the keychain has a diameter of 4 mm.</p><p>I recommend bending the joint manually after printing, so that it closes the holder properly later.</p><p>One important last thing:</p><p>I have a good gut feeling about the holder, but I have not yet been able to test it for a long time. So please don't use it to transport sd cards that you can't afford to lose!!! Thanks</p><p>Please leave a comment or shoot me a message if you like the holder or have any ideas how it could or should be improved. Thank you! :-)</p><p>If it does not work for you please leave a comment or shoot me a message instead of just posting a 1 star review, I'm sure there is no problem that can't be solved.</p><h3>Print Settings</h3><p><strong>Printer Brand:</strong></p><p>Creality</p><p> </p><p><strong>Printer: </strong></p><p>Ender 3</p><p><strong>Supports:</strong></p><p> </p><p>No</p><p> </p><p><strong>Infill: </strong></p><p>40% Gyroid</p><p><br/><strong>Filament:</strong><br/><br/>AmazonBasics PLA light Grey <br/> </p><p><strong>Notes: </strong></p><p>No supports needed.<br/>I sliced it with 0.12 mm layer height in Cura.</p><p>Printing time is approx. 20 minutes</p><p> </p><p> </p><p> </p><p>Category: Organization</p>