Tiny Hawk II Freestyle add ons

thingiverse

Arm protectors that slide onto the frame, safeguarding it and the screws that secure the motors in place. All four designs are identical. An XT30 holder is also included, which attaches to the back using existing screws. Printed with PETG 100% infill, supports were added everywhere on the arm protectors and touching the build plate for the XT30 holder. Prior to printing, I scaled up to 1000% in my slicer; double-check your scale settings before printing. On June 29, an alternative style XT30 holder was introduced, which screws onto the back, replacing two frame standoffs. It sits at a 45-degree angle. Printing requires supports everywhere and may take a little longer; I printed mine at 35mm/s. On July 5, another arm guard was added, featuring a hump to prevent sliding or falling off during crashes. However, this design necessitates printing with flexible filament. Supports are still required for the overhang. On September 20, the rear piece was updated to allow antenna wires to pass through several holes. Small lower holes can be used to secure motor wires if necessary.