Tiny Apple Watch Nightstand... Stands... *NEW*

thingiverse

Update 18th of January 2016 As gratitude for numerous downloads and constructive feedback, updated versions are now available for both sizes along with an entirely new version for each size. Files named H6 have been revamped from the previous iteration to feature a thicker frame which should withstand charger insertion without breakage. Minimal sanding or filing is still necessary unless scaling up to 101-103% precision is achieved; exact measurement variation depends on individual printer characteristics. Support structure and raft requirements apply for this updated version. Files labeled T1 represent new additions, exhibiting an even more compact size that does not require support materials whatsoever. Cable outlets at a slightly steeper angle may possibly conflict with some filaments, thus providing prompt feedback would be beneficial to facilitate necessary adjustments. Design optimizations enabled by higher angle outlet render flat positioning achievable without requiring any tacking devices; however custom nylon straps appear satisfactory though valuable user feedback remains welcomed. Inclusive removal of the raft comprises finish-work. Size specifications corresponding to 38mm designs have not been validated, so kindly provide immediate notification in case discrepancies arise. The only settings employed during printing comprise a layer height of 0.2mm, three shells with eight percent infill rate, accompanied by a raft for support in the updated version 'H6,' while version T1 was executed without any auxiliary structures. Watch-inspired charging stands resembling Apple's nightstand mode now have been adapted and are ready for practical use as showcased through images. Secure the lower side using blue-tack if needed to minimize possible movement; further enjoyment is anticipated by end users. Instructions: To properly initiate build procedure Rotate print head ninety degrees to align the flat surface of the base with the printing platform; recommended print settings involve applying 0.2mm layer height and achieving at least two shells; in addition, a minimal rafts requirement exists but no supports are essential except when employing the updated H6 variant.