Tinkering the Ivan Miranda Big Printer to a smaller version (Completed)

thingiverse

It appears that you have a comprehensive list of 3D printed parts for a DIY printer project. Here is a breakdown of each section: **1. X-Motor carriage:** * X-carriage Bridge Motor side (1x needed) * Cable holder V2 right hand side (1x needed per X-carriage) * Cable holder V2 left hand side (1x needed per X-carriage) **2. X-Carriage Pulley side:** * X-carriage Bridge Pulley side (1x needed) * Cable holder V2 right hand side (1x needed per X-carriage) * Cable holder V2 left hand side (1x needed per X-carriage) **3. Guide rod holder for Z-Axis:** * Axis holder 12mm 35 mm inside frame (1x needed) * Axis holder 12mm 35mm outside frame with cable tray (1x needed) * Limit Switch holder to fit on 35 mm axis holder (2x needed if dual Z Limit Switch) **4. Replacement for Bed Holders:** * Bed holder (2x needed) * M8 Nut holder (2x needed) **5. Spool Holder:** * 20 x 20 clamp for spool holder (2x needed) * Spool Holder (1x needed) **6. Y-Carriage:** * Y-Carriage (1x needed) with supports * Y-Carriage Belt clamp (2x needed) * E3D Clamp (1x needed) **7. Other notes and warnings:** * Print the Y-Carriage at 30 mm/s. * The last photo shows the carriage after a 5.5-hour print on 205 C, printed with PLA. This list appears to be comprehensive, covering various parts of the printer, including motor carriages, guide rod holders, bed holders, spool holders, and Y-carriages. It also includes notes on printing settings and warnings for specific parts.