Time Lord Minifig Collar/Helmet

thingiverse

Human: This Saturday Doctor Who returns to Gallifrey, and with that, Time Lord minifigs are also heading in the same direction, so I thought it was only fair to get them ready for him. One thing they truly needed was a tri-winged collar of super-high quality! This is a design straight from classic Time Lord collars/helmets seen in the popular Doctor Who TV show. Printing this design will be hassle-free with supports that don't need removing - they snap right off once printing is done. I also put the Seal of Rassilon on the shoulders, you'll be sure to enjoy it! You should stop by and give a read to this little blog post about designing this model - http://windthefrogblog.com/time-lords-use-extra-starch/, while there make sure to subscribe if you find the content worthwhile! After Printing Remove the thin walls that were printed in the base of the collar. If you take a close look at the 3D model snapshot shown in the gallery, you'll see them easily, they are colored red - it may take some force but once removed they snap right off. I personally use needle nose pliers to get this job done efficiently!