TiltBridge ESP32 OLED Enclosure

prusaprinters

<p>This is an enclosure for the generic "OLED" style of ESP32 board. It is designed to be secured with 4x M3 square nuts &amp; 4x M3 16mm bolts.</p> <p>Due to the fact that the OLED screens are affixed to the PCB using double sided tape, virtually no two of these boards have the OLED screen in the same place. This design has been created as Thingiverse Customizer enabled to allow for the OLED hole to be shifted up/down to accomodate the placement of the OLED screen on<em>your</em> PCB. This is also the reason that no STL has been included for the lid - you will almost certainly want to customize the lid to match the dimensions of your board.</p> <p>To customize this board, measure the exact distance from the bottom of the PCB to the start of the displayable portion of the OLED screen (i.e. where you want the hole to be).</p> <p>This enclosure was originally designed for the TiltBridge project but should work with any project that uses this board.</p> Category: Kitchen & Dining