Tight fit arc for Led Arc Lamp

thingiverse

This is remixed from https://www.thingiverse.com/thing:2477162 This is ONLY the arc piece, all other original pieces used. This piece was made to have a snug fit and not require any glue in the arc. Precision is key for this, as tolerances are minimal. I used two-wall with .4 nozzle and .2 layer in the Bambu "standard" profile. 0% infill, 3 layers of top and bottom. I did use a brim of 5mm for adhesion. I modified the "pegs" that go into the other side for a very snug fit. The original design was very loose and requires glue, this design requires precision printing, but otherwise no glue at all. It is snug enough to be simply pressed together, and it holds well enough to support the entire weight when holding from one end alone. I chose 0% infill because it didn't seem to help at all anyway, and there are no spaces that are very large. I also removed the cross sections at the two ends to give it a uniform X path through the entire model. This is the only piece I modified from the original, please use all other parts from the original.