Tig Tungsten Grinder

thingiverse

TIG/WIG Grinding Tool for Dremel Multitools Release 01.07.2019 03.07.2019 Adds 60 deg and Combi Head for all 3 Angles 23.11.2019 Adds Heads with 1.0mm Diameter 06.01.2020 Adds Absaugung (Extraction) Feature What You Need: Dremel Multitool, 35mm Diamond Grinding Disk (Available on eBay) Each Head has 3 Positions that can be Used, Each Position uses a Different Radius on the Grinding Disk. Diameter Options: 1.0mm, 1.6mm, and 2.4mm Angle Options: 30 deg, 45 deg, and 60 deg, as well as Combi Head Health and Safety Warning: You Do It at Your Own Risk How to Set Up: Step 1: Insert the shaft of the grinding wheel into the collet chuck and tighten it slightly. The shaft should still move a bit and stick out of the lower part. Then, screw the lower part of the tool onto the Dremel. Step 2: Put the grinding wheel onto the shaft without the screw. Use the top part of the tool to press the grinding wheel and the shaft into the correct position. When it fits properly with the lower part, proceed to the next step. Step 3: Remove the lower part of the tool from the Dremel and tighten up the collet chuck. Step 4: Screw the lower part back onto the Dremel, fit the grinding wheel with the shaft, and screw on the needed top part. Use a 2.5mm or 1.7mm drill to open up holes if necessary, or use a hot TIG electrode. Ready to Grind! Other diameters and angles are possible upon request.