Tie Fighter Interceptor Kit Card

prusaprinters

This model was featured on The 3D Printing NerdWe love the Star Wars Kit Cards by benzz88 Edabot Nakozen and delman83After designing the millennium falcon kit card, I thought I would try to design a tie interceptor to go with the other star wars kit cards we've printed for his office.Make sure to check out:My Millennium Falcon Kit CardTie Fighter Ornament by EdabotX-Wing Kit Card by NakozenY-Wing Kit Card by NakozenA-Wing Kit Card by Delman83B-Wing Kit Card by Delman83This was made to fit when printed on my homemade hypercube300 printer which is not the highest precision printer in the world, so you may have to adjust the holes, or use a little glue depending on how dialed in your printer is. Adjusting the z-scale slightly up or down without changing the x & y scale can help as well.There are two versions included. One with a ring for hanging, or using as an ornament, and one without a ring.Printed card is 120mm X 120mm to fit on most printers.Assembled Model is roughly 82mm X 63mm X 50mm.Print SettingsPrinter:Hypercube300 Rafts: NoSupports: No Resolution: 0.2Infill: 25%Filament: Hatchbox PLA Gray  Notes: Example is printed at 0.2 layer height, but some of my earlier tests seemed to fit a little better with 0.12 layer heights, so your mileage may vary.   Category: Vehicles