Tick Remover V3

thingiverse

**Disclaimer**: I want to make it clear that I don't claim this is the best way to remove a tick or the safest method. I also don't guarantee a 100% success rate at removing ticks. Please use this information at your own discretion and after doing your own research. If you're not comfortable using this method, consider contacting a medical professional who is more suitable for these tasks. This is a new redesign of the original Tick Remover, featuring significant modifications that should improve its performance. While it may not be as visually appealing, this design should work just as well, if not better, than the original. I initially preferred the half-sphere design, but unfortunately, it didn't translate well to printing. The bowl design was too thin at the base, causing printers to lay down insufficient filament to make it sturdy enough. As a result, a hole would appear, which was completely unintentional and defeated the purpose of holding the tick safely without dropping it. Since the half-sphere design wasn't feasible, I opted for a box design instead. Fortunately, this one printed exactly as intended. The same warning applies here: use this information at your own risk and after conducting thorough research. I created this remix as a separate entity because it's a completely new design that deserves its own page. I hope others find this version more appealing than the original. If you can improve on either design, please do so - your input is greatly appreciated!