ThunderTiger Neptune SB-1 sidetanks

thingiverse

Construct side tanks for ThunderTiger Neptune SB-1 using the following steps. Print part 1 twice for each side and part 2 or 3 similarly. Table 2 represents the midsection of the tank, while Table 3 is the same but with a lid, fitting Maxi size Kinder Suprise egg containers. Attach 2x200mm threaded rods in each large piece and slide on slim mountpieces and caps from part 2. Place the tanks beside the SB-1 hull and mark the height of 5mm holes on the mountpieces onto the hull, indicating where dead ballast will be housed. Mark two points 13.7mm apart on either side to mirror on the other side of the hull. Attach 5mm rods through these holes and secure tanks with locking rings at rod ends, utilizing niching in mountpieces and hole alignment for tightening with a hex key.