Thrustmaster T3PA Pedal Vibration Motor Mount

thingiverse

So, on the back of the T3PA pedals, there is an unused mounting hole behind the Throttle pedal. Perfect for mounting up a vibration motor hot glued into a 25mm conduit saddle mount clip. I had done this mod with an Arduino to feel vibration when locked up wheels with ABS or sliding due to excessive drifting skills. You'll see the way I mounted the vibration motor, stripped out of an old gamepad. A 5mm bolt and nut clamp this to the bracket and two 3mm pk screws into the pedal base. Keep the 3mm screws into the pedal base fairly short, no more than about 5mm deep. Check out my mods and other work at oznzsimracing.com. Here is a link - http://oznzsimracing.com/forums/m/16887284/viewthread/29285694-3d-modellingprinting-sketchup-fusion360. Here is another one - http://oznzsimracing.com/forums/m/16887284/viewthread/29305339-pagnian-gt-ultimate-wheel-stand-problems-fixes. And here is the last one - http://oznzsimracing.com/forums/m/16887284/viewthread/23526371-ramjetx-simrig-other-stuff. Printer Settings: Printer Brand: Wanhao Printer: Wanhao Duplicator i3 V2 Rafts: No Supports: No Resolution: 0.2mm worked fine Infill: 20% Notes: Nothing special, no supports needed. It's supposed to vibrate and transfer vibration energy to the pedal base, so more infill the better for transmitting vibration.