Thrustmaster T300 etc Pedal potentiometer gear

thingiverse

This should replace worn or damaged pot gears. It can happen with pedals like the T3PA etc. I've only tested it on my T300RS pedals, which are a lower-end two-pedal set. However, I believe all pots and gears are identical across the range. Print slowly (10-20mms) and finely (0.15mm layers). Use PLA with plenty of cooling to keep it crisp. I printed it on a raft for the first time - normally I don't use rafts - but it turned out well. The pitch of the teeth is slightly off, but close enough that it should work fine.