ThrustMaster HOTAS X StreamDeck Mount

cults3d

Having tried an existing design, I was disappointed that, after a 4 hour print, it was not complete and didn't quite fit as I would have liked. I spent the several days designing and testing a totally new version using measurements from the TM HOTAS X. Several versions later (and endless hours of print tests) I came up with something that fitted reasonably well, and was relatively easy to print. The main unit will print in about four hours, followed by about an hour for the other parts. Requirements: The two existing 4x14mm bolts; two additional 4x14 (or longer) bolts; and two small 10-12mm 2.5mm self tapping screws for the cable clamp. Instructions: Print the main unit; the top; two supports; and the cable clamp. Glue the supports to the inside of the top and then glue the top on to the main body. Separate the two controls of the HOTAS using the allen key on the underside of the joystick. Unwind enough cable from the throttle unit to allow the unit to fit in-between the two controls. Fit and screw the two controls to the unit using the existing 4mm screws, and two additional 4mm screws. Feed any loose cable into the provided channel and into the unit. Feed the Stream Deck USB cable down into the unit and out of the hole in the back. Fit the cable clamp using the two self-tapping screws, keeping about 150mm of cable on the inside of the unit. Push-fit the Stream Deck adjustable mount down into the hole in the top of the unit making sure the USB cable sits in the recess. Set the adjustable mount to your liking; fit the Stream Deck; and feed the loose USB cable down into the unit. You may want to use a small amount of double sided tape to hold the Stream Deck in place. Adjust the mount to your liking, and you're done... o7