ThrustMaster HOTAS X StreamDeck Mount

thingiverse

Human: <b><i>Please consider supporting my work with a beer token via PayPal at paypal.me/geoffsim59/1</i></b> After experimenting with an existing design, I was let down by the fact that it took four hours to print and didn't fit as well as I had hoped. Over several days, I created and tested a completely new version based on measurements from the TM HOTAS X. After numerous iterations and countless hours of test prints, I came up with a design that fit reasonably well and was relatively easy to print. The main unit takes approximately four hours to print, followed by about an hour for the other parts. Requirements: * The two existing 4x14mm bolts * Two additional 4x14 (or longer) bolts * And two small 10-12mm 2.5mm self-tapping screws for the cable clamp Instructions: Print the main unit, top, two supports, and cable clamp. Attach the supports to the inside of the top and then glue the top onto the main body. Separate the two controls of the HOTAS using an allen key on the underside of the joystick. Release enough cable from the throttle unit to allow the unit to fit between the two controls. Secure the two controls to the unit using the existing 4x14mm bolts, and two additional 4x14 (or longer) bolts. Feed any loose cable into the provided channel and into the unit. Feed the Stream Deck USB cable down into the unit and out of the hole in the back. Install the cable clamp using the two self-tapping screws, leaving about 150mm of cable inside the unit. Push-fit the Stream Deck adjustable mount down into the hole in the top of the unit, ensuring the USB cable sits in the recess. Adjust the mount to your liking, install the Stream Deck, and feed the loose USB cable down into the unit. You may want to use a small amount of double-sided tape to secure the Stream Deck in place. Adjust the mount as needed, and you're done!