Thread Finder - SAE

prusaprinters

This is a set of thread testers for nuts and bolts, U.S. / SAE standard. Similar to the “Thread Detective” where one side tests a nut, the other side tests a bolt. Thread sizes are embossed on the side of each tester.This is a set in common SAE sizes.There is a hole through the side of the testers to hang them from a chain or rope.These should print fine if your printer is dialed in pretty well. Make sure initial layer / elephant foot compensation is set up otherwise it may be hard to get a screw threaded.I would think these would print well on a SLA resin printer if you have “Tolerance compensation” configured in Chitubox or “Elephant foot compensation” in PrusaSlicer.Print SettingsPrinter: Ender 3 Pro w/ direct driveMaterial: PLA or PETGRafts: NoSupports: NoResolution: 0.15-0.2mmInfill: 15% or higherShells: 2+Note: These came out solid enough in my opinion with 15% cubic infill.