
Thread Compass inspired by Boris Vallejo
prusaprinters
Faden-Kompass inspiriert durch Boris VallejoAuf einem Bild von Boris Vallejo (1983) sieht man eine neben einem Pegasus ähnlichem Pferd (mit Flügeln) kniende Frau die so vermute ich so einen am Faden befestigten “Eisenstein” Kompass benutzt.Gesehen hier:https://cp12.nevsepic.com.ua/62/1353959762-0440780-www.nevsepic.com.ua.jpgZur vervollständigung benötigt man einen Neodym-Magneten Durchmesser 6mm und 3mm hoch.Dieser wird in die unten liegende Öffnung eingesetzt.Wenn man danach einen dünnen Faden (am besten möglichst dünnes Nähgarn) ca. 30cm lang an der Öse befestigt sollte der Kompass je nach Einsetzrichtung des Magneten mit dem Kopf nach Norden b.z.w. Süden aus pendeln und somit die Richtung weisen.Bei nicht-Gebrauch kann man das Teil als Kettenanhänger benutzen.Viel Spaß :-)--------------------------------------------------------------------Google translates:Thread Compass inspired by Boris VallejoIn a picture by Boris Vallejo (1983) a woman is shown kneeling beside a Pegasus-like horse (with wings) who I suspect is using an 'ironstone' compass attached to a thread.Seen here:https://cp12.nevsepic.com.ua/62/1353959762-0440780-www.nevsepic.com.ua.jpegTo complete it, you need a neodymium magnet with a diameter of 6mm and a height of 3mm.This is inserted into the opening below.If you then attach a thin thread (preferably thin sewing thread) about 30cm long to the eyelet, the compass should point north or north depending on the direction in which the magnet is inserted.Commuting from the south and thus pointing the way.When not in use, you can use the part as a pendant.Have fun :-)
With this file you will be able to print Thread Compass inspired by Boris Vallejo with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Thread Compass inspired by Boris Vallejo.