Thorn hand cannon - split into 8 for 20cm cubed

thingiverse

I cut up a Thorn print job into eight manageable pieces to fit on my Da Vinci 1.0 printer (20cm x 20cm x 20cm). Currently printing, it's expected to take about twenty hours total to finish the print job. The filament used is one kilogram of Hatchbox red filament. To assemble the piece without issues, be sure to score the sides that are glued together carefully. The Design I employed Autodesk to slice up the original Thorn design into more workable pieces. I followed these steps: Printing Instructions You can access these instructions at destinystlgenerator.com. Follow these procedures for a clean and precise print job: First, run your model through a repair program or mesh modeler to eliminate any defects. Next, adjust the size of each piece so that it prints accurately within its bounds.