Thor's hammer Mjolnir Lamp

thingiverse

Human prints details on Hammer head design:\nThickness: 0.3 millimeters for exterior layer.\nPrinting fill rate of five percent.\nDouble spiral paths with two circuits each, in top-to-bottom formation.\non top side and the lower part: solid printing thickness at one point two millimeters\nOthers are built as follows,\nthickness on the layer: zero point three millimeters. Filling structure: twenty percent density.\nsolid spiral pathways: loops with two turns each;\nin the up-and-down pattern with a thin, single print line six tenths of a millimeter.