Thinner Spool Hole Spool Holder

thingiverse

http://www.youtube.com/watch?v=oly6A4GSLD0 Smaller Spool Hole Spool Holder for Replicator, Flashforge, Wanhao and Others with a 30mm Rear Opening. The original factory holder was 30mm thick and often too bulky for most spools. In contrast, this revised holder measures just 20mm in thickness, making it ideal for accommodating all types of spools. Both nuts come pre-stretched to 104% for effortless compatibility with PLA. The model is print-ready and can be successfully printed without any form of support or rafting when using PLA material. To assemble the parts, users will need to download and print each individual component - two separate nut holders and one single screw piece. Key Printing Details: * Printer: Utilized CTC Replicator Dual with standard factory firmware. * Material: High-quality 1.75mm PLA. * Nozzle Size: Precise control using a 0.4mm/0.5mm nozzle configuration. * Build Surface: Achieved optimal adhesion with a painters tape setup. * Printing Settings: + Infill percentage: Opted for an infill level of 10%. + Shell thickness: Consisted of two outer shells. + Layer Height: Delicate print details with each layer height measuring 0.2mm. + Supports: Entire model printed without support features or any form of rafting present. + Extruder Temperature: Set to an ideal temperature range of 230°C during extrusion processes. + Build Plate Temperature: Standard factory default value of "off" was maintained throughout the printing process. + Speed (Extr/Travel): Implemented a balance between extrusion and travel speeds by adjusting values to 90 mm/s and 150 mm/s, respectively.